3200mAh Analog Cable Path Meter and Fault Locator for Accurate Cable Path Detection

Output signal: intermittent: 0～50Vpp

Output power: 100W

Output current: 0～2A

Output frequency: 15kHz intermittent

Receiving mode: Magnetic sound synchronization

Receiving frequency: audio frequency

Magnification: 50,0000 times

Output impedance :350Ω

Quiescent current: less than 10Ma

Operating temperature:-10 ~ 55°C

Test buried depth of the cable

When you judge the buried depth of the cable, you can place the probe at an angle of 45 degrees with the ground on the position of the cable that has been measured, "move outward" perpendicular to the path. Find the most minor sound point in the middle of the probe, then the distance the probe moves is the buried depth of the cable. For the above operation essentials, please refer to the schematic diagram of probe placement in the following figure.

Schematic diagram of probe placement